Xerox WorkCentre 5687 Series Service Manual page 1462

REP 11.3-171 Top Tray
Parts List on PL 11.130
Removal
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
Remove the top tray as follows:
1. If fitted, undock the PPI, REP 11.82-171.
2. Remove the top and rear covers REP 11.1-171.
3. Disconnect the links from the tray, Figure 1.
1
Lift the tray and pull the
link eyes from the lugs
on the tray
Figure 1 Link Disconnection
4. Remove the bias spring and pin, Figure 1.
5. Remove the shaft front and rear circlips and bushes. Lift the top tray from the shaft, Figure
2.
Repairs/Adjustments
REP 11.3-171
NOTE: Remove the idler pulley to avoid straining the drive belt when removing the shaft
drive pulley.
Replacement
Reverse the removal procedure to reinstall the HVF top tray.
2
Remove the pin
and spring
August 2007
4-442
3
Remove the shaft bushes
and un-clip the tray.
Figure 2 Shaft drive and support bushes
WorkCentre 5687 Family
2
Remove the
shaft drive pulley.
1
Remove the
outer pulley