Xerox WorkCentre 5687 Series Service Manual page 1554

REP 11.63-171 Entry Feed Motor
Parts List on PL 11.150
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the rear cover REP 11.1-171.
2. Remove the entry feed motor and bracket assembly, Figure 1.
Tension Spring
Figure 1 Entry Feed Motor and Bracket
3. Remove 2 screws and the grounding wire to remove the motor and damper from the
bracket.
Replacement
Reverse the removal procedures to replace the entry feed motor.
Set the belt tension ADJ 11.10-171.
Repairs/Adjustments
REP 11.63-171, REP 11.64-171
REP 11.64-171 Bypass Feed Motor
Parts List on PL 11.150
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the rear cover REP 11.1-171.
2. Remove the bypass feed motor and bracket assembly, Figure 1.
1
Remove the 2
bracket screws
2
Remove the pivot
screw
3
Disconnect the
motor PJ.
3. Remove 2 screws and the grounding wire to remove the motor and damper from the
bracket.
Replacement
Reverse the removal procedures to replace the bypass feed motor.
Set the belt tension, ADJ 11.10-171.
August 2007
4-534
WARNING
WARNING
Tension Spring
Figure 1 Bypass Feed Motor and Bracket
1
Remove the pivot and
2 bracket screws
2
Disconnect the
motor PJ.
WorkCentre 5687 Family