Xerox WorkCentre 5687 Series Service Manual page 1540

REP 11.59-171 Crease Roll Gate Assembly
Parts List on PL 11.167
Purpose
This procedure is used to repair the following components:
• Crease roll gate rack gear, PL 11.167 Item 8.
• Crease roll gate rack drive gear, PL 11.167 Item 13.
• Crease roll gate rack, PL 11.167 Item 14.
• Crease roll gate front guide, PL 11.167 Item 15.
• Crease roll gate rear guide, PL 11.167 Item 16.
• Crease roll gate, PL 11.167 Item 19.
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Open the HVF BM front door and fully pull out the BM.
2. Remove the crease blade knob (6d), PL 11.161 Item 4.
3. Remove the crease roll handle (6c), PL 11.161 Item 5.
4. Remove the BM front cover, PL 11.161 Item 3.
5. Remove the BM right hand cover, REP 11.56-171.
6. Remove the crease roll gate motor, REP 11.24-171.
Repairs/Adjustments
REP 11.59-171
7. Figure 1, remove the crease roll gate rack drive gear and both crease roll gate rack gears.
Figure 1 Removing gears
August 2007
4-520
1
Remove the E-clip and 2 gears
2
Remove E-clip
and gear
WorkCentre 5687 Family