Table of Contents
Advertisement
g.
Select Read/Write and decrease the value by 80, this will return the NVM value to
the original setting.
h.
Select Save, select OK, select Close, select Exit.
i.
Re-install the BM right hand cover, if removed in step 5.
9.
If the sheet is not correctly aligned, perform the adjustment.
Adjustment
1.
Do the following
a.
Enter dC131.
b.
Select Diagnostic Routines.
c.
Select Copier Routines.
d.
Select dC131 NVM Read/Write.
e.
Select 12Finisher/DFA.
f.
Select 12-003 BookMkrCompileOff-set.
g.
Select Read/Write and enter the new value to correct the error found during the
check. Increasing the value will raise the sheet. Decreasing the value will lower the
sheet. One step = 0.1137mm.
h.
Select Save, select OK, select Close, select Exit.
2.
Repeat the Check to ensure the compiling position is correctly set.
3.
Do the following:
a.
Enter dC131.
b.
Select Diagnostic Routines.
c.
Select Copier Routines.
d.
Select dC131 NVM Read/Write.
e.
Select 12Finisher/DFA.
f.
Select 12-003 BookMkrCompileOff-set.
g.
Select Read/Write and decrease the value by 80.
h.
Select Save, select OK, select Close, select Exit.
i.
Re-install the BM right hand cover, if removed in step 5.
4.
When the compiling position is correct, switch the machine off then on, GP 14.
Repairs/Adjustments
ADJ 11.6-170, ADJ 11.7-170
ADJ 11.7-170 Booklet Crease Position
Purpose
To set the crease position of the booklet in relation to the left edge of the top sheet of the book-
let.
Check
1.
Run a copy job of 3 stapled 4 sheet booklets.
2.
Observe the position of the crease in relation to the open end of the booklet. The fold
should be central, so that the open end of the booklet pages are equal from the fold. If
necessary perform the adjustment.
Adjustment
1.
Perform the following:
a.
Enter dC131.
b.
Select Diagnostic Routines.
c.
Select Copier Routines.
d.
Select 131 NVM Read/Write...
e.
Select 12Finisher/DFA...
f.
Select 12-005 BookMrkFoldOffset.
g.
Select Read/Write.
h.
Enter the new value to correct the error found during the check.
NOTE: Increasing the value increases the width of the top sheet of the booklet
(moves the fold away from the left edge). Decreasing the value decreases the width
of the top sheet of the booklet (moves the fold towards the left edge). One step =
0.1137mm.
i.
Select Save, then OK.
2.
Select Save, then select OK.
3.
When the crease position is correct, switch the machine off then on, GP 14.
August 2007
4-664
WorkCentre 5687 Family
Hide quick links:
Advertisement
Chapters
Table of Contents
