Xerox WorkCentre 5687 Series Service Manual page 1570

REP 11.86-171 PP Inserter Clutch
Parts List on PL 11.179
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the PPI rear cover. REP 11.83-171.
2. Disconnect the clutch PJ and remove the circlip and the bearing from the feed roll shaft,
Figure 1.
3. Remove the 4 screws and the bracket then slide the clutch from the shaft
NOTE: The reverse roll drive idler and the drive belt are not attached to the clutch bracket
or the PPI frame.
Bearing
FOR CLARITY
INSERTER MOTOR
Reverse roll drive
NOT SHOWN
idler
Figure 1 Inserter Clutch Removal
Repairs/Adjustments
REP 11.86-171
Bracket
Inserter Clutch
Reverse roll drive
belt
Reverse roll drive
pulley
August 2007
4-550
Replacement
Reverse the removal procedures to replace the PP Inserter clutch.
When replacing the bracket, check that the clutch torque arm locates in the locating tab. Put
the reverse roll drive belt over the drive idler and check that the reverse roll idler gear shaft
locates properly into the frame.
When the bracket is secured, temporarily remove the circlip and the reverse roll drive pulley to
replace the drive belt over the reverse roll drive pulley.
WorkCentre 5687 Family