Xerox WorkCentre 5687 Series Service Manual page 1516

REP 11.41-171 HVF PPI Guide Roll
Parts List on PL 11.155
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine GP 14. Disconnect the power cord from the cus-
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the HVF front door, REP 11.1-171.
2. Remove the HVF top cover, REP 11.1-171.
3. Remove the HVF front cover, REP 11.1-171.
4. Remove the HVF rear cover, REP 11.1-171.
5. Open guide 8a.
6. Figure 1. At the front of the HVF, remove the circlip and the bush.
Figure 1 Circlip and bush removal.
Repairs/Adjustments
REP 11.41-171
7.
Replacement
Remove the circlip
and the bush
The replacement procedure is the reverse of the removal procedure.
August 2007
4-496
Figure 2. At the rear of the HVF, remove the PPI guide roll.
REAR VIEW
Figure 2 PPI guide roll removal
1
Remove the circlip
2
Slide the pulley and the
bush along the shaft
3
Slip the belt off of
the pulley
4
Remove the pulley and
the bush
5
Remove the PPI
guide roll
WorkCentre 5687 Family