Xerox WorkCentre 5687 Series Service Manual page 1555

REP 11.65-171 Buffer Feed Motor
Parts List on PL 11.150
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the rear cover REP 11.1-171.
2. Remove the buffer feed motor and bracket assembly, Figure 1.
Tension Spring
Figure 1 Buffer Feed Motor and Bracket
3. Remove 2 screws and the grounding wire to remove the motor and damper from the
bracket.
Replacement
Reverse the removal procedures to replace the buffer feed motor.
Fit the pivot screw and set the belt tension, ADJ 11.10-171. Do not tighten the motor bracket
screws fully until the belt is tensioned by the spring.
WorkCentre 5687 Family
REP 11.66-171 Exit Feed Motor
Parts List on PL 11.150
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the rear cover REP 11.1-171.
2. Remove the exit feed motor and bracket assembly, Figure 1.
1
Remove the
pivot and 2
bracket screws
2
Disconnect the
motor PJ.
Tension Spring
3. Remove 2 screws and the grounding wire to remove the motor and damper from the
bracket.
Replacement
Reverse the removal procedures to replace the exit feed motor.
Fit the bracket pivot screw and set the belt tension, ADJ 11.10-171.
August 2007
4-535
WARNING
WARNING
1
Remove the
pivot and 2
bracket screws
2
Disconnect the
motor PJ.
Figure 1 Exit Feed Motor and Bracket
REP 11.65-171, REP 11.66-171
Repairs/Adjustments