Xerox WorkCentre 5687 Series Service Manual page 1471

REP 11.11-171 Front Tamper Drive Assembly
Parts List on PL 11.140
Removal
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
WARNING
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the front door and front cover REP 11.1-171.
2. Remove the front tamper. Remove the tamper motor and bracket assembly, Figure 1.
Figure 1 Front Tamper Drive Assembly
Replacement
Reverse the removal procedures to reinstall the front tamper drive assembly.
WorkCentre 5687 Family
REP 11.12-171 Stacker Motor Gearbox Assembly
Parts List on PL 11.135
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine, GP 14. Disconnect the power cord from the
customer supply, while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Remove the front and rear covers REP 11.1-171.
2. Remove the rear drive belt lower pulley to relieve the belt tension.
3. Remove the stacker motor and gearbox assembly Figure 1.
NOTE: The pulley pin may fall when the pulley is removed.
Tamper motor and
bracket assembly
Front tamper
3
Release the wiring
from the clamps
Replacement
Reverse the removal procedures to reinstall the stacker motor gearbox assembly.
NOTE: Check that the 'flats' on the shaft bearing align with the cut-outs in the bracket.
Check that the Bin 1 lift bar is level before refitting the stacker belt lower pulley.
August 2007
4-451
WARNING
WARNING
2
1
Remove the
Remove the circlip,
bearing.
the upper pulley and
the pin.
Figure 1 Stacker Motor Gearbox Assembly
REP 11.11-171, REP 11.12-171
Repairs/Adjustments