Clear The Autosw-Sfber-Sncp Condition - Cisco NCS 2000 series Troubleshooting Manual

Clear the AUTOSW-SFBER-SNCP Condition

Clear the AUTOSW-SFBER-SNCP Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the SF (TRUNK) Condition, on page 390
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-UNEQ (STSMON)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON
The Automatic Path Protection Switch Caused by Unequipped condition indicates that an
423, caused automatic path protection switching to occur. If the path protection is configured for revertive
switching, it reverts to the working path after the fault clears.
Note
This condition is only reported if the path protection is set up for revertive switching.
Clear the AUTOSW-UNEQ (STSMON) Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the UNEQ-P Alarm, on page 424
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
140
Clear the SF (TRUNK) Condition, on page 390
Clear the UNEQ-P Alarm, on page 424
procedure.
procedure.
procedure.
http://www.cisco.com/c/en/us/support/index.html
procedure.
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
UNEQ-P , on page