Cisco NCS 2000 series Troubleshooting Manual page 542

Error Messages Reference
Error/Warning
ID
EID-2320
EID-2321
WID-2322
EID-2323
EID-2324
EID-2325
WID-2326
WID-2327
EID-2328
EID-2329
EID-2330
EID-2331
EID-2332
EID-2333
EID-3001
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
496
Error/Warning Message
This VCAT circuit does not support deletion of its
member circuits.
An error occurred while deleting member circuits. {0}
Not all cross-connects from selected circuits could be
merged into the current circuit. They might appear as
partial circuits.
The circuit roll failed. Bridge and roll is not supported
on monitor circuits.
An error occurred during the circuit upgrade. {0}
You have failed {0} times to unlock this session. CTC
will exit after you click OK or close this dialog box.
Currently, CTC does not support bridge and roll on
circuits that are entirely created by TL1. To continue
with bridge and roll in CTC, the selected circuits must
be upgraded. Is it OK to upgrade the selected circuits
and continue the bridge and roll operation?
Currently, CTC does not support bridge and roll on
circuits that are partially created by TL1. To continue
with bridge and roll in CTC, the selected circuits must
be upgraded. Is it OK to upgrade the selected circuits
and continue the bridge and roll operation?
An error occurred during the circuit reconfiguration.
{0}
{0} of {1} circuits could not be successfully created.
An error occurred during circuit verification. The
selected {0} is invalid! {1}
Deleting {0} might be service affecting.
A validation error occurred in row {0}. {1} hold-off
timer for {2} must be between {3}-10,000 ms, in steps
of 100 ms.
The SSLIOP port cannot have the same port value as
IIOP port. Please change it and apply again.
An Ethernet RMON threshold with the same parameters
already exists. Please change one or more of the
parameters and try again.
Error Messages
Description
You can not delete a circuit that is a
member of VCAT circuit.
Refer to the error message text.
Refer to the warning message text.
A monitor circuit does not support
Bridge and Roll.
Refer to the error message text.
The maximum amount of attempts to
unlock this session has been reached.
Refer to the warning message text.
Refer to the warning message text.
The attempt to reconfigure the
specified circuit has failed.
A few circuits could not be created.
The selected item, specified by {0}, is
invalid as per the details, specified in
{1}.
Deleting the item can affect the service
of CTC.
Refer to the error message text.
Refer to the error message text.
Change a few parameters in an
Ethernet remote monitoring (RMON)
threshold and try again.