Clear The Lpbkterminal (Escon) Condition - Cisco NCS 2000 series Troubleshooting Manual

Clear the LPBKTERMINAL (ESCON) Condition

Clear the LPBKTERMINAL (ESCON) Condition
SUMMARY STEPS
1. Complete the
455
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
LPBKTERMINAL (FC)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: FC
A Loopback Terminal condition for the FC payload occurs on an FC when a software terminal (inward)
loopback is active for an MXP_MR_2.5G, MXPP_MR_2.5G, TXP_MR_2.5G, TXPP_MR_2.5G, GE-XP,
and 10GE-XP card client PPM (SFP) provisioned at the FC1G, FC2G, FICON1G, or FICON2G line speed.
For information about troubleshooting these circuits with loopbacks, refer to the
XP, or ADM-10G Circuit Paths With Loopbacks, on page 7
Clear the LPBKTERMINAL (FC) Condition
SUMMARY STEPS
1. Complete the
455
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
296
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
procedure.
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
procedure.
http://www.cisco.com/c/en/us/support/index.html
Troubleshooting MXP, TXP,
section.
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting
procedure.
procedure.