Chanloss - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
3. Verify that the MA-Domain Mapping is correct. Click Provisioning > CFM > Configuration >
MA-Domain Mapping
DETAILED STEPS
Step 1 In card view, click the Provisioning > CFM > Configuration > MEP tabs.
Step 2
Do the following to ensure that the maintenance association and the domain names are the same.
a) In card view, click the Provisioning > CFM > Configuration > MA Profiles tabs.
b) Enter or note down the maintenance profile name.
c) In card view, click the Provisioning > CFM > Configuration > Domain Profiles tabs.
d) Enter or note down the domain profile name.
e) Repeat steps a to d on the other end of the maintenance end point.
The maintenance profile name and the domain profile name must be the same on both the maintenance end points.
Step 3
Verify that the MA-Domain Mapping is correct. Click Provisioning > CFM > Configuration > MA-Domain Mapping
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

CHANLOSS

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: OCN
The SONET Section Layer DCC Termination Failure condition occurs when the NCS receives unrecognized
data in the section layer DCC bytes.
Warning Invisible laser radiation could be emitted from the end of the unterminated fiber cable or connector.
Do not stare into the beam directly with optical instruments. Viewing the laser output with certain
optical instruments (for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm
could pose an eye hazard. Statement 1056
Warning
Use of controls, adjustments, or performing procedures other than those specified could result in
hazardous radiation exposure. Statement 1057
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
CHANLOSS
157