Cisco NCS 2000 series Troubleshooting Manual page 550

Error Messages Reference
Error/Warning
ID
EID-3140
EID-3141
EID-3142
EID-3143
EID-3144
EID-3145
EID-3146
EID-3147
EID-3148
EID-3149
EID-3150
EID-3151
EID-3152
EID-3153
EID-3154
EID-3155
EID-3156
EID-3157
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
504
Error/Warning Message
A higher priority switch is already active.
An attempt was made to access a bad reference.
No switch is active.
An error occurred while creating the static route entry.
The maximum number of static routes has been
exceeded.
The RIP metric must be between 1 and 15.
The RIP metric is invalid.
An error occurred while creating the summary address.
No Layer 2 domain has been provisioned.
The MAC addresses could not be retrieved.
The target file {0} is not a normal file.
The target file {0} is not writable.
An error occurred while creating the protection group.
The card cannot be deleted because it is in use.
An error occurred while provisioning the card: CTC
cannot {0} the card.
An error occurred while building the menu.
An error occurred while building the menu. Cards were
not found for the {0} group.
The selected model could not be set because of an
unexpected model class: {0}.
Error Messages
Description
You cannot switch the timing source
manually when a higher priority
switch is already active.
Refer to the error message text.
None of the switches are active.
CTC encountered an error while a
creating static route entry.
The number of static routes has
exceeded its limit.
The Routing Information Protocol
(RIP) metric should be in the range of
1 to 15.
Refer to the error message text.
There was an error while creating the
summary address.
You must provision any one of the
layer 2 domain.
Refer to the error message text.
The specified target file is not a
normal file.
The target file is not writeable. Specify
another file.
CTC encountered an error creating
Protection Group.
Refer to the error message text.
CTC cannot perform the task on the
card.
CTC encountered an error building the
menu.
CTC encountered an error while
building the menu, as cards could not
be found for the specified group).
CTC encountered an unexpected
model class while trying to complete
the task.