Lmp-Unalloc - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

LMP-UNALLOC

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: GE
The LMP Data Link Unallocated condition is raised when the control card receives an LMP link summary or
channel status message reporting that the data link as unallocated for data traffic. The condition clears when
the data link is allocated and sends an LMP link summary or channel status message to this effect. If a data
link has the LMP-UNALLOC alarm raised against it, this should suppress all other alarms on the client port,
since the far-end node is not using the errored port. (Consequently you do not have to clear any alarms on the
far-end node unused port.)
LMP-UNALLOC is part of an alarm hierarchy that includes
257. The hierarchy is as follows: If LMP-UNALLOC is raised, LMP-SF and LMP-SD are suppressed. If
LMP-SF is raised, it suppresses LMP-SD. LMP-SF and LMP-UNALLOC both suppress near-end LOS-type
DWDM client alarms, but LMP-SD does not.
In most cases, this condition is an informational notice at the near-end node that the far-end port is not being
utilized. If, however, the far-end port should be allocated for traffic, log into the Technical Support Website
at http://www.cisco.com/cisco/web/support/index.html
553-2447)..
LOCAL-CERT-CHAIN-VERIFICATION-FAILED
Default Severity: Major (MJ), Non-Service-Affecting (NSA)
Logical Object: EQPT
The Local Certificate Chain Verification Failed alarm is raised when the verification of an active certificate
chain in the card fails.
Clear the LOCAL-CERT-CHAIN-VERIFICATION-FAILED Alarm
This alarm is cleared when the verification of an active certificate chain in the card is pass.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
http://www.cisco.com/c/en/us/support/index.html
LMP-SD, on page
for more information or call Cisco TAC (1 800
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
LMP-UNALLOC
256, and LMP-SF, on page
259