Manwkswbk-No-Trfsw - Cisco NCS 2000 series Troubleshooting Manual

MANWKSWBK-NO-TRFSW

MANWKSWBK-NO-TRFSW
The Manual Switch Back To Working Resulted in No Traffic Switch (MANWKSWBK-NO-TRFSW) condition
occurs when you perform a Manual switch to the working port or card and the working port or card is already
active.
This transient condition does not result in a standing condition.
MANWKSWPR-NO-TRFSW
The Manual Switch to Protect Resulted in No Traffic Switch (MANWKSWPR-NO-TRFSW) condition occurs
when you perform a Manual switch to the protect port or card and the protect port or card is already active.
This transient condition results in a BLSR or MSSP Manual Switch (Span or Ring) standing condition.
MCAST-MAC-ALIASING
This condition is raised when there are multiple L3 addresses that map to the same L2 address in a VLAN.
MSSP-RESYNC
The MS-SPRing Multi-Node Table Update Completed (MSSP-RESYNC) condition occurs when a node
receives all relevant information such as payload, path state, Routing Information Protocol (RIP), cross-connect
tables, and cross-connect VT tables from the other nodes in the ring. This condition is raised on all nodes in
the ring while a node is added or a circuit is provisioned. This transient condition will not be cleared and is
seen in the History tab of CTC.
You must check this condition on all the nodes and then remove the Forced Ring Switch commands.
PM-TCA
The Performance Monitoring Threshold Crossing Alert (PM-TCA) condition occurs when network collisions
cross the rising threshold for the first time.
PS
The Protection Switch (PS) condition occurs when traffic switches from a working/active card to a
protect/standby card.
REP-PRI-EDGE-ELECTED
The REP-PRI-EDGE-ELECTED condition occurs in GE_XP and 10GE_XP cards when the primary edge
port is elected in a segment. The condition is raised on the primary REP port.)
REP-SEC-EDGE-ELECTED
The REP-SEC-EDGE-ELECTED condition occurs in GE_XP and 10GE_XP cards when the secondary edge
port is elected in a segment. The condition is raised on the primary REP port.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
474
Transient Conditions