Clear The Autoreset Alarm - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
Logical Object: EQPT
The Automatic System Reset alarm occurs when you change an IP address or perform any other operation
that causes an automatic card-level reboot. AUTORESET typically clears after a card reboots (up to ten
minutes).
Resets performed during a software upgrade also prompt the condition. This condition clears automatically
when the card finishes resetting. If the alarm does not clear, complete the following procedure.

Clear the AUTORESET Alarm

SUMMARY STEPS
1. Determine whether there are additional alarms that could have triggered an automatic reset. If there are,
troubleshoot these alarms using the applicable section of this chapter.
2. If the card automatically resets more than once a month with no apparent cause, complete the
Replace a Card, on page 453
DETAILED STEPS
Step 1
Determine whether there are additional alarms that could have triggered an automatic reset. If there are, troubleshoot
these alarms using the applicable section of this chapter.
Step 2 If the card automatically resets more than once a month with no apparent cause, complete the
on page 453 procedure.
Warning High-performance devices on this card can get hot during operation. To remove the card, hold it by the
faceplate and bottom edge. Allow the card to cool before touching any other part of it or before placing
it in an antistatic bag. Statement 201
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-AIS
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: STSMON, VT-MON
The Automatic Path Protection Switch Caused by an AIS condition indicates that automatic path protection
switching occurred because of an AIS condition. If the path protection is configured for revertive switching,
it reverts to the working path after the fault clears. The AIS also clears when the upstream trouble is cleared.
Note
This condition is only reported if the path protection is set up for revertive switching.
Generally, any AIS is a special SONET signal that communicates to the receiving node when the transmit
node does not send a valid signal. AIS is not considered an error. It is raised by the receiving node on each
procedure.
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Clear the AUTORESET Alarm
Physically
Physically Replace a Card,
133