Lpbkfacility (Fc) - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

LPBKFACILITY (FC)

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: FC
A Loopback Facility condition for the FC payload occurs on a fibre channel (FC) line when a software facility
(line) loopback is active for an MXPP_MR_2.5G, MXP_MR_2.5G, TXPP_MR_2.5G, and TXP_MR_2.5G
card client PPM (SFP) provisioned at the FC1G, FC2G, FICON1G, or FICON 2G line speed.
For information about troubleshooting these circuits with loopbacks, refer to the
XP, or ADM-10G Circuit Paths With Loopbacks, on page
Note For general information about MXP and TXP cards and provisioning them, refer to the Provision Transponder
and Muxponder Cards chapter in the Cisco ONS 15454 DWDM Configuration GuideCisco NCS 2000 Series
Configuration Guide.
Clear the LPBKFACILITY (FC) Condition
SUMMARY STEPS
1. Complete the
455
DETAILED STEPS
Complete the Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page 455
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
LPBKFACILITY (GE)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: GE
A Loopback Facility condition for a Gigabit Ethernet (GE) port occurs when a software facility (line) loopback
is active for an MXP_MR_2.5G, MXPP_MR_2.5G, TXP_MR_2.5G, TXPP_MR_2.5G, GE-XP, 10GE-XP,
and ADM-10G card client PPM (SFP) provisioned at the ONE_GE port rate. For the TXP_MR_10E and
Clear an MXP, TXP, GE-XP, 10GE-XP, and ADM-10G Card Loopback Circuit, on page
procedure.
http://www.cisco.com/c/en/us/support/index.html
7.
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
LPBKFACILITY (FC)
Troubleshooting MXP, TXP,
procedure.
293