Awg-Overtemp - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
DETAILED STEPS
For the alarmed 40MUX, 32WSS-O, 40WSSC-C, 32DMX, or 40DMX card, complete the
on page 453 procedure.
High-performance devices on this card can get hot during operation. To remove the card, hold it by the
Warning
faceplate and bottom edge. Allow the card to cool before touching any other part of it or before placing
it in an antistatic bag. Statement 201
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.

AWG-OVERTEMP

Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: OTS
The AWG Over Temperature alarm is raised if a 40MUX, 32WSS-O, 40WSSC-C, 32DMX, or 40DMX card
having an AWG-FAIL alarm is not replaced and its heater-control circuit temperature exceeds 212 degrees
F (100 degrees C). The card goes into protect mode and the heater is disabled.
Clear the AWG-OVERTEMP Alarm
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the AWG-FAIL Alarm, on page 142
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.
AWG-WARM-UP
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: OTS
to obtain a directory of toll-free Technical Support numbers for
Clear the AWG-FAIL Alarm, on page 142
procedure.
to obtain a directory of toll-free Technical Support numbers for
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
for more information or log into
procedure.
for more information or log into
AWG-OVERTEMP
Physically Replace a Card,
http://www.cisco.com/c/
http://www.cisco.com/c/
143