Cisco NCS 2000 series Troubleshooting Manual page 580

Error Messages Reference
Error/Warning
ID
EID-6013
EID-6014
EID-6015
EID-6016
EID-6017
EID-6018
EID-6019
EID-6020
EID-6021
EID-6022
EID-6023
EID-6024
EID-6025
EID-6026
EID-6027
EID-6028
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
534
Error/Warning Message
The NTP/SNTP server could not be changed.
{1}
The operation failed because the reference state is OOS.
The distance extension cannot be disabled if the port
media type is FICON 1Gbps ISL or FICON 2Gbps ISL.
The card mode cannot be changed to Fibre Channel
Line Rate if the port media type is FICON 1Gbps ISL
or FICON 2Gbps ISL.
The destination of a {0} route cannot be a node IP
address.
The destination of a {0} route cannot be the same as
the subnet used by the node.
The destination of a static route cannot be
255.255.255.255
The destination of a static route cannot be the loopback
network (127.0.0.0/8).
The subnet mask length for a non default route must
be between 8 and 32.
The subnet mask length for a default route must be 0.
The destination of a {0} route cannot be an internal
network{1}.
The destination of a {0} route cannot be a class D
(224.0.0.0/4) or class E (240.0.0.0/4) address.
The destination of a {0} route cannot be a class A
broadcast address (x.255.255.255/8).
The destination of a {0} route cannot be a class B
broadcast address (x.x.255.255/16).
The destination of a {0} route cannot be a class C
broadcast address (x.x.x.255/24).
The destination of a {0} route cannot be the subnet
broadcast address associated with a node IP address.
Error Messages
Description
Refer to the error message text.
Change the Out-of-service state to
Active.
Refer to the error message text.
Refer to the error message text.
A node IP address cannot be the
destination for a static route.
Refer to the error message text.
The network address such as
255.255.255.255 is not valid. Enter a
valid address.
Refer to the error message text.
Length of subnet mask must be within
the specified range.
Refer to the error message text.
The destination of a static route must
not be an internal network.
The destination of a static route must
not be a class D or class E address.
The destination of a static route must
not be a class A broadcast address. It
should be (xxx.0.0.0).
The destination of a static route must
not be a class B broadcast address.
The destination of a static route must
not be a class C broadcast address.
The destination of a static route must
not be a subnet broadcast address of a
node IP.