Fe-Frcdwkswpr-Span - Cisco NCS 2000 series Troubleshooting Manual

FE-FRCDWKSWPR-SPAN

FE-FRCDWKSWPR-SPAN
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STMN
The Far End Working Facility Forced to Switch to Protection Span condition occurs from a far-end node
when a span on a four-fiber BLSR is forced from working to protect using the Force Span command. This
condition is only visible on the network view Conditions tab. The port where the Force Switch occurred is
indicated by an F on the network view detailed circuit map. This condition is accompanied by WKSWPR.
Clear the FE-FRCDWKSWPR-SPAN Condition
SUMMARY STEPS
1. To troubleshoot an FE condition, determine which node and card link directly to the card reporting the
FE alarm.
2. Log into the node that links directly to the card reporting the FE condition.
3. Clear the main alarm.
4. If the FE-FRCDWKSWPR-SPAN condition does not clear, complete the
Command, on page
DETAILED STEPS
Step 1
To troubleshoot an FE condition, determine which node and card link directly to the card reporting the FE alarm.
Step 2 Log into the node that links directly to the card reporting the FE condition.
Step 3
Clear the main alarm.
Step 4 If the FE-FRCDWKSWPR-SPAN condition does not clear, complete the
on page 448procedure.
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
FE-MANWKSWBK-SPAN
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STMN
The Far End Manual Switch Back to WorkingSpan condition occurs when a far-end span is Manual switches
back to working.
Note
WKSWBK-type conditions apply only to nonrevertive circuits.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
198
448procedure.
Clear a BLSR External Switching
Clear a BLSR External Switching Command,
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting