Alarm Troubleshooting
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-PDI-SNCP
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP, VCMON-LP
The Automatic UPSR Switch Caused by Payload Defect Indication (PDI) condition indicates that automatic
UPSR protection switching occurred because of a PDI alarm. If the UPSR is configured for revertive switching,
it reverts to the working path after the fault clears.
Note
This condition is only reported if the SNCP is set up for revertive switching.
Clear the AUTOSW-PDI-SNCP Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the
Clear the PDI-P Condition, on page 353
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-SDBER
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON, VT-MON
The Automatic Path Protection Switch Caused by Signal Degrade Bit Error Rate (SDBER) condition indicates
that a
is configured for revertive switching, the path protection reverts to the working path when the SD-P is resolved.
Note
This condition is only reported if the path protection is set up for revertive switching.
Clear the PDI-P Condition, on page 353
SD-P , on page 387
condition caused automatic path protection switching to occur. If the path protection
http://www.cisco.com/c/en/us/support/index.html
procedure.
procedure.
http://www.cisco.com/c/en/us/support/index.html
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
AUTOSW-PDI-SNCP
137