Clear The Autosw-Lop-Sncp Alarm - Cisco NCS 2000 series Troubleshooting Manual

Clear the AUTOSW-LOP-SNCP Alarm

Note This condition is only reported if the SNCP is set up for revertive switching.
Clear the AUTOSW-LOP-SNCP Alarm
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the AU-LOP Alarm , on page 130
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-PDI
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON, VT-MON
The Automatic Path Protection Switch Caused by Payload Defect Indication (PDI) condition indicates that
automatic path protection switching occurred because of a
is configured for revertive switching, it reverts to the working path after the fault clears.
Note This condition is only reported if the path protection is set up for revertive switching.
Clear the AUTOSW-PDI Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the PDI-P Condition, on page 353
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
136
Clear the AU-LOP Alarm , on page 130
procedure.
Clear the PDI-P Condition, on page 353
procedure.
procedure.
http://www.cisco.com/c/en/us/support/index.html
PDI-P , on page 352 alarm. If the path protection
procedure.
Alarm Troubleshooting