Cisco NCS 2000 series Troubleshooting Manual page 593

Error Messages
Error/Warning
ID
EID-6287
EID-6288
EID-6289
WID-6290
WID-6291
EID-6292
EID-6294
EID-6295
EID-6296
EID-6297
EID-6298
EID-6299
EID-6300
WID-6301
EID-6302
EID-6303
EID-6304
EID-6305
EID-6306
WID-6307
Error/Warning Message
You cannot edit the {0} {1}.
The BERT configuration is invalid.
The BERT mode is not yet configured
The BERT mode is configured in unframed format
Port has circuits; configuring the BERT mode will
disrupt normal traffic.
The alarm type name cannot exceed 20 characters
The alarm type name contains invalid characters. Only
the following characters are valid: 0-9, A-z, a-z and "-".
The alarm type is in use and cannot be deleted.
Maximum number of alarm types that can be added
cannot exceed 50.
Hard coded alarm types cannot be deleted.
The alarm type already exists.
The alarm type does not exist.
Selective auto negotiation is allowed only when selected
speed and duplex modes are non-auto. Click "Reset"
to revert the changes.
Selective auto negotiation applies only to copper SFPs.
Users are not allowed to perform this operation.
The ITU-T G.709 configuration cannot be disabled
when Fast Protection is enabled.
Users are not allowed to perform this operation.
The view could not be deleted.
The ITU-T G.709 configuration cannot be disabled
when Fast Protection is enabled.
You have only selected one trunk-to-trunk patchcord.
For complete deletion, you must select both patchcords
that are attached to the 10GE_XP/GE_XP cards. Do
you want to continue?
Description
Port rate of Optical and Electrical ports
cannot be changed while circuits are
provisioned on them.
Refer to the eror message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
When logged in as a maintenance user
provisioning operation is not allowed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
547