Cisco NCS 2000 series Troubleshooting Manual page 551

Error Messages
Error/Warning
ID
EID-3158
EID-3159
EID-3160
EID-3161
EID-3162
EID-3163
EID-3164
EID-3165
EID-3166
EID-3167
EID-3168
EID-3169
Error/Warning Message
Probable causes: - Unable to switch, because a similar
or higher priority condition exists on a peer or far-end
card. - A loopback is present on the working port. -
Protect port is in OOS disabled admin state
An error occurred while applying the operation.
An error occurred while provisioning the {0}.
An error occurred while upgrading the ring.
This protection operation cannot be set because the
protection operation on the other side has been changed
but not yet applied.
The data in row {0} cannot be validated.
The new node ID ({0}) for ring ID {1} duplicates the
ID of node {2}.
The ring ID provided is already in use. Ring IDs must
be unique.
An error occurred while refreshing the {0} table.
The slot is already in use.
An error occurred while provisioning.
An error occurred while adding the card.
Description
Refer to the error message text.
CTC encountered an error while
applying this operation.
EID-3159 can appear if you attempt
to perform another switching operation
within a certain time interval. This
interval is an algorithm of three
seconds per working card in the
protection group. The maximum
interval is 10 seconds.
CTC encountered the specified error.
An error was encountered while
attempting to upgrade the BLSR.
Refer to the details portion of the error
dialog box for more information.
Refer to the error message text.
CTC cannot validate the data for the
specified row.
The new specified node ID for the
specified ring ID is the same as
another node ID.
Refer to the error message text.
CTC encountered an error while
refreshing the specified table.
Refer to the error message text.
An error was encountered while
attempting the specified provisioning
operation. Refer to the details portion
of the error dialog box for more
information.
CTC encountered an error while
adding the card.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
505