Cisco NCS 2000 series Troubleshooting Manual page 544

Error Messages Reference
Error/Warning
ID
EID-3025
EID-3026
EID-3027
EID-3028
EID-3029
EID-3031
EID-3032
EID-3033
EID-3035
EID-3036
EID-3039
EID-3040
EID-3041
EID-3042
EID-3046
EID-3047
EID-3048
EID-3049
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
498
Error/Warning Message
An error occurred while retrieving thresholds.
The send DoNotUse attribute cannot be modified.
The SyncMsg attribute cannot be modified.
The port type cannot be changed.
Unable to switch to the byte because an overhead
change is present on this byte of the port.
An error occurred while hard-resetting the card.
An error occurred while resetting the card.
The lamp test is not supported on this shelf.
The cross-connect diagnostics cannot be performed
The cross-connect diagnostics test is not supported on
this shelf.
An error occurred while changing the card type.
The card type is invalid.
An error occurred while applying changes.
The flow control low value must be less than the flow
control high value for all ports in the card.
The flow control watermark value must be between {0}
and {1}, inclusive.
The file {0} could not be read. Please verify the name
and try again.
There is no Cisco IOS startup configuration file
available to download.
The download cannot be done at this time because an
update in progress.
Error Messages
Description
There was an error retrieving the
thresholds.
You cannot modify the Send
DoNotUse field.
You cannot modify the SyncMsg field.
You cannot change the port type.
Refer to the error message text.
There was an error while resetting card
hardware.
There was an error while resetting the
card.
Refer to the error message text.
Refer to the error message text.
The cross-connect diagnostics test is
not supported on this shelf.
There was an error while changing the
card.
The selected card type is invalid.
CTC is unable to create a protection
group. Check if the protect port
supports circuits, a timing reference,
SONET SDCC, orderwire, or a test
access point.
Refer to the error message text.
The flow control watermark value
must be between the two specified
values.
Refer to the error message text.
CTC could not find the configuration
file for IOS startup.
Refer to the error message text.