Cisco NCS 2000 series Troubleshooting Manual page 563

Error Messages
Error/Warning
ID
EID-3395
EID-3397
EID-3398
EID-3399
EID-3400
EID-3401
EID-3402
EID-3403
EID-3404
EID-3405
EID-4000
EID-4001
Error/Warning Message
The configuration is invalid. {0}
The file {0} is the wrong version.
The PPM cannot be deleted.
The PPM cannot be deleted because it has port(s) in
use.
Unable to switch. A force to the primary facility is not
allowed.
{0} cannot be provisioned for the port while {1} is
enabled.
The switch request could not be completed. The {0}
card is not present or is not responding. Try again after
ensuring that the {0} card is present and is not resetting.
The administrative state transition has not been
attempted on the monitored port.
The far end IP address could not be set on the {0}
termination. The IP address cannot be: loopback
(127.0.0.0/8)
class D (224.0.0.0/4)
class E (240.0.0.0/4)
broadcast (255.255.255.255/32)
internal {1}
You cannot change card parameters with port {0} in
{1} state. Click "Reset" to revert the changes.
The {0} ring name cannot be changed now because a
{0} switch is active.
The {0} node ID cannot be changed now because a {0}
switch is active.
Description
CTC encountered an error in IP
address, net mask length, or default
router, or a restricted IIOP port was
selected.
The specified file is of wrong version.
Refer to the error message text.
Remove the ports connected to the
Pluggable Port Module before it can
be deleted.
Refer to the error message text.
The relationship between parameters
{0} and {1} are such that enabling
either one, prevents the provisioning
of the other.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
You cannot change the ring name
because a switch of the same ring type
is active.
You cannot change the ring ID
because a switch of the same ring type
is active.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
517