Cisco NCS 2000 series Troubleshooting Manual page 577

Error Messages
Error/Warning
ID
EID-5160
EID-5161
EID-5162
EID-5163
EID-5164
EID-5165
EID-5166
EID-5167
Error/Warning Message
Maintenance state cannot be set on CRS.
Please use Synchronize IPoDWDM to synchronize.
Some of the effected routers could not be brought back
into IS.
The circuit must be in the DISCOVERED state in order
to start a PPT.
Unable to retrieve the Shelf info.
Requested operation cannot be completed.
Unable to perform Maintenance synchronization
operation.
Source is not fully specified.
Unable to set the Transport Admin State on the CRS
{0}
Description
Refer to the error message text.
Complete node information could not
be retrieved.
Refer to the error message text.
The node, shelf, or slot is not selected.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.
• The node name/node IP address
or link source/link destination
information could not be
retrieved.
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.
• Cisco CRS node connectivity is
down.
• XML interface on the Cisco CRS
is not reachable.
• Not enough memory on the Cisco
CRS.
531