Table of Contents
Advertisement
Alarm Troubleshooting
DETAILED STEPS
Complete the
Clear the AIS Condition, on page 116
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-LOP (STSMON)
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STSMON
The Automatic Path Protection Switch Caused by LOP condition for the STS monitor (STSMON) indicates
that automatic path protection switching occurred because of the
protection is configured for revertive switching, it reverts to the working path after the fault clears.
Note
This condition is only reported if the path protection is set up for revertive switching.
Clear the AUTOSW-LOP (STSMON) Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the
Clear the LOP-P Alarm, on page 270
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-LOP-SNCP
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP, VCMON-LP
An Automatic UPSR Switch Caused by LOP alarm indicates that an automatic UPSR protection switching
occurred because of the
switches back to the working path after the fault clears.
procedure.
Clear the LOP-P Alarm, on page 270
procedure.
AU-LOP , on page
130. If the UPSR ring is configured for revertive switching, it
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
AUTOSW-LOP (STSMON)
http://www.cisco.com/c/en/us/support/index.html
LOP-P , on page 270
procedure.
http://www.cisco.com/c/en/us/support/index.html
alarm. If the path
135
Advertisement
Table of Contents
Troubleshooting
