Autosw-Sfber - Cisco NCS 2000 series Troubleshooting Manual

Hide thumbs Also See for NCS 2000 series:

Table of Contents

Alarm Troubleshooting

AUTOSW-SFBER

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

Logical Object: STSMON, VT-MON

The Automatic USPR Switch Caused by Signal Fail Bit Error Rate (SFBER) condition indicates that a

, on page 392

for revertive switching, the path protection reverts to the working path when the SF-P is resolved.

This condition is only reported if the path protection is set up for revertive switching.

Clear the AUTOSW-SFBER Condition

SUMMARY STEPS

1. Complete the

DETAILED STEPS

Complete the

Clear the SF-P Condition, on page 392

If the condition does not clear, log into the Technical Support Website at

for more information or call Cisco TAC (1 800 553-2447).

AUTOSW-SFBER-SNCP

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

Logical Object: VCMON-HP, VCMON-LP

The Automatic UPSR Switch Caused by Signal Fail Bit Error Rate (SFBER) condition indicates that a signal

fail caused automatic UPSR protection switching to occur. If the UPSR ring is configured for revertive

switching, it reverts to the working path when the SF is resolved.

This condition is only reported if the SNCP is set up for revertive switching.

condition caused automatic path protection switching to occur. If the path protection is configured

Clear the SF-P Condition, on page 392

http://www.cisco.com/c/en/us/support/index.html

Cisco NCS 2000 series Troubleshooting Guide, Release 11.0

AUTOSW-SFBER