Clear The Autosw-Sfber-Sncp Condition; Autosw-Uneq-Sncp; Clear The Autosw-Uneq-Sncp Condition; Bkupmemp - Cisco ONS 15600 SDH Troubleshooting Manual

2.6.18 AUTOSW-UNEQ-SNCP

This condition is only reported if the SNCP is set up for revertive switching.
Note

Clear the AUTOSW-SFBER-SNCP Condition

Complete the
Step 1
same for all signal degrade and signal fail alarms).
If the condition does not clear, log into the Technical Support Website at
Step 2
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).
2.6.18 AUTOSW-UNEQ-SNCP
The Automatic SNCP Switch Caused by Unequipped Circuit condition indicates that an
condition on page 2-69
configured for revertive switching, it reverts to the working path after the fault clears.
This condition is only reported if the SNCP is set up for revertive switching.
Note

Clear the AUTOSW-UNEQ-SNCP Condition

Step 1 Complete the
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1 800 553-2447).

2.6.19 BKUPMEMP

The Primary Non-Volatile Backup Memory Failure alarm refers to a problem with the TSC card flash
memory. The alarm occurs when the controller card is in use and has one of four problems:
•
•
•
•
Cisco ONS 15600 SDH Troubleshooting Guide, R8.0
2-26
"Clear the MS-EXC Condition" procedure on page
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP
alarm caused automatic SNCP protection switching to occur. If the SNCP is
"Clear the HP-UNEQ Alarm" procedure on page
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Object: EQPT
Flash manager fails to format a flash partition.
Flash manager fails to write a file to a flash partition.
Problem at the driver level.
Code volume fails cyclic redundancy checking (CRC, a method to verify for errors in data
transmitted to the TSC card).
Chapter 2 Alarm Troubleshooting
2-99. (The clearing procedure is the
"HP-UNEQ"
2-69.
July 2010