Clear The Autosw-Sdber Condition - Cisco NCS 2000 series Troubleshooting Manual

Clear the AUTOSW-SDBER Condition

Clear the AUTOSW-SDBER Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the SD-P Condition, on page 388
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
AUTOSW-SDBER-SNCP
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: VCMON-HP, VCMON-LP
The Automatic UPSR Switch Caused by Signal Degrade Bit Error Rate (SDBER) condition indicates that a
signal degrade caused automatic UPSR protection switching to occur. If the UPSR ring is configured for
revertive switching, it reverts to the working path when the SD is resolved.
Note
This condition is only reported if the SNCP is set up for revertive switching.
Clear the AUTOSW-SDBER-SNCP Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the SD (TRUNK) Condition, on page 385
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
138
Clear the SD-P Condition, on page 388
procedure.
Clear the SD (TRUNK) Condition, on page 385
procedure.
http://www.cisco.com/c/en/us/support/index.html
procedure.
procedure.
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting