Cisco NCS 2000 series Troubleshooting Manual page 529

Error Messages
Error/Warning
ID
EID-2006
EID-2007
EID-2008
EID-2009
EID-2010
EID-2011
EID-2012
EID-2013
EID-2014
EID-2015
EID-2016
EID-2017
EID-2018
EID-2019
EID-2020
EID-2021
EID-2022
EID-2023
Error/Warning Message
An error occurred while editing the circuit(s). {0} {1}.
The preferences could not be saved.
The circuit preferences could not be saved: {0}
CTC was unable to download the package: {0}
An error occurred while deleting the destination.
The circuit could not be destroyed.
The reverse circuit could not be destroyed.
The circuit creation failed. The circuit creation cannot
proceed due to changes in the network which affected
the circuit(s) being created. The dialog box will close.
Please try again.
No circuit(s) were selected. {0}
The circuit {0} cannot be deleted because it has one or
more rolls.
The circuit deletion failed.
An error occurred while mapping the circuit. {0}
The circuit roll failed. The circuit must be in the
DISCOVERED state in order to perform a roll.
The circuit roll failed. Bridge and roll is not supported
on DWDM circuits.
The circuit roll failed. The two circuits must have the
same direction.
The circuit roll failed. The two circuits must have the
same size.
The circuit roll failed. A maximum of two circuits can
be selected for a bridge and roll operation.
CTC was unable to create a new user account.
Description
An error occurred when CTC tried to
open the circuit for editing.
CTC cannot save the preferences.
CTC cannot find the file needed to
save the circuit preferences.
Refer to the error message text.
CTC could not delete the destination.
CTC could not destroy the circuit.
CTC could not reverse the circuit
destroy.
Refer to the error message text.
You must select a circuit to complete
this function.
You must delete the rolls in the circuit
before deleting the circuit itself.
CTC could not delete the tunnel as
there are circuits that use the tunnel.
There was an error mapping the
circuit.
There was a failure in circuit roll.
Change the circuit state to
DISCOVERED and proceed.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
483