Ms-Exc - Cisco NCS 2000 series Troubleshooting Manual

MS-EXC

DETAILED STEPS
Complete the Clear the RS-EOC Alarm, on page 381
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
MS-EXC
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
Logical Object: STM1E
The Multiplex Section Signal Excessive BER condition is similar to the
alarm, but applies only to the multiplex section overhead of the EQPT object.
Clear the MS-EXC Condition
SUMMARY STEPS
1. Complete the
DETAILED STEPS
Complete the Clear the SDBER-EXCEED-HO Condition, on page 389
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).
MS-RFI
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
Logical Object: STM1E, STMN
The MS Remote Fault Indication (RFI) condition indicates that there is an RFI occurring at the SONET
overhead multiplexing section level.
An RFI occurs when the NCS detects an RFI in the SONET overhead because of a fault in another node.
Resolving the fault in the adjoining node clears the MS-RFI condition in the reporting node.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
308
procedure.
Clear the SDBER-EXCEED-HO Condition, on page 389
http://www.cisco.com/c/en/us/support/index.html
SDBER-EXCEED-HO , on page 388
procedure.
procedure.
http://www.cisco.com/c/en/us/support/index.html
Alarm Troubleshooting