Mem-Gone - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
If the condition does not clear, log into the Technical Support Website at
for more information or call Cisco TAC (1 800 553-2447).

MEM-GONE

Default Severity: Major (MJ), Service-Affecting (SA)
Logical Object: EQPT
The Memory Gone alarm occurs when data generated by software operations exceeds the memory capacity
of the control cards. The control cards which exceed the memory capacity reboot to avoid failure of card
operations.
Note
The alarm does not require user intervention. The MEM-LOW alarm always preceeds the MEM-GONE alarm.
MEM-LOW
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
Logical Object: EQPT
The Free Memory of Card Almost Gone alarm occurs when data generated by software operations is close
to exceeding the memory capacity of the control cards. The alarm clears when additional memory becomes
available. If additional memory is not made available and the memory capacity of the card is exceeded, CTC
ceases to function.
The alarm does not require user intervention.
If the condition does not clear, log into the Technical Support Website at
index.html
MFGMEM
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Objects: AICI-AEP, AICI-AIE, AIP, BPLANE, FAN, PPM, ECU, LCD, PWRM
EEPROM stores manufacturing data that a system uses to determine system compatibility and shelf inventory
information.
The Manufacturing Data Memory Failure alarm occurs when:
• EEPROM fails on a card or component.
• The control card cannot read data from EEPROM.
for more information or call Cisco TAC (1 800 553-2447).
http://www.cisco.com/c/en/us/support/index.html
http://www.cisco.com/c/en/us/support/
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
MEM-GONE
305