Cisco NCS 2000 series Troubleshooting Manual page 560

Error Messages Reference
Error/Warning
ID
EID-3335
EID-3336
EID-3337
EID-3338
EID-3339
EID-3340
EID-3341
EID-3342
EID-3343
EID-3344
EID-3345
EID-3346
EID-3347
EID-3348
EID-3349
EID-3350
EID-3351
EID-3352
EID-3353
EID-3354
EID-3355
EID-3357
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
514
Error/Warning Message
The port type cannot be changed because the SDH
validation check failed. Check if this port is part of a
circuit, protection group, SONET DCC, orderwire, or
UNI-C interface.
An error occurred while reading a control mode value.
An error occurred while setting a set point gain value.
An error occurred while reading a set-point gain value.
An error occurred while setting a tilt calibration value.
An error occurred while setting expected wavelength.
An error occurred while reading expected wavelength.
An error occurred while reading actual wavelength.
An error occurred while reading actual band.
An error occurred while reading expected band.
An error occurred while setting expected band.
An error occurred while retrieving defaults from the
node: {0}.
The file {0} cannot be loaded.
Properties cannot be loaded from the node.
NE update properties cannot be saved to a file.
NE update properties cannot be loaded from the node.
The file {0} does not exist.
An error occurred while setting a value at {0}.
No such interface is available.
The specified endpoint is in use.
The specified endpoint is incompatible.
The connections could not be calculated.
Error Messages
Description
Refer to the error message text.
The Control Mode must be retrieved.
The Gain Set Point must be set.
The Gain Set Point must be retrieved.
The tilt calibration must be set.
The expected wavelength must be set.
The expected wavelength must be
retrieved.
The actual wavelength must be
retrieved.
The actual band must be retrieved.
The expected band must be retrieved.
The expected band must be set.
There was an error retrieving defaults
from the specified node.
CTC cannot load the specified file.
Refer to the error message text.
Check your file system for space
constraint or any other problem.
Refer to the error message text.
The specified file does not exist.
There was an error while setting the
value at the specified location.
The interface specified is not present
in CTC.
Select another endpoint that is not in
use.
Refer to the error message text.
Refer to the error message text.