Clear The Ilk-Fail Alarm - Cisco NCS 2000 series Troubleshooting Manual

Alarm Troubleshooting
•

Clear the ILK-FAIL Alarm

SUMMARY STEPS
1. Clear the root-cause service-affecting alarm by using one of the following procedures, as appropriate:
DETAILED STEPS
Clear the root-cause service-affecting alarm by using one of the following procedures, as appropriate:
• Clear the LOS (TRUNK) Alarm, on page 279
• Clear the LOF (TRUNK) Alarm, on page 265
• Clear the SF (TRUNK) Condition, on page 390
If the alarm does not get cleared, you need to report a Service-Affecting (SA) problem. Log into the Technical Support
Website at http://www.cisco.com/c/en/us/support/index.html
en/us/support/web/tsd-cisco-worldwide-contacts.html
your country.
IMPROPRMVL
Default Severity: Critical (CR), Service-Affecting (SA)
Logical Objects: EQPT, PPM
The Improper Removal (IMPROPRMVL) alarm occurs under the following conditions:
• A card is removed when the card was rebooting. It is recommended that after the card completely reboots,
• When a card is deleted from CTC before physically removing the card from its slot. It is recommended
• A card is inserted into a slot but is not fully plugged into the backplane.
• A PPM (SFP) is provisioned but the physical module is not inserted into the port.
SF (TRUNK) , on page 390
delete the card in CTC and only then remove the card physically. When you delete the card, CTC loses
connection with the node view (single-shelf mode) or shelf view (multishelf mode), and goes to network
view.
that the card be physically removed from its slot before deleting it from CTC.
Note CTC provides the user approximately 15 seconds to physically remove the card
before it begins rebooting the card.
It can take up to 30 minutes for software to be updated on a standby control card.
alarm
procedure
procedure
procedure
for more information or log into
to obtain a directory of toll-free Technical Support numbers for
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Clear the ILK-FAIL Alarm
http://www.cisco.com/c/
235