Cisco NCS 2000 series Troubleshooting Manual page 586

Error Messages Reference
Error/Warning
ID
EID-6119
EID-6120
WID-6121
EID-6122
EID-6123
EID-6124
EID-6125
EID-6126
EID-6127
EID-6128
EID-6129
EID-6135
EID-6136
EID-6137
EID-6138
EID-6139
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
540
Error/Warning Message
The shelves could not be rearranged. {0}
This equipment does not support multishelf.
This internal patchcord cannot be provisioned because
the endpoints have no compatible wavelengths.
The wizard could not be started. {0}
The OSI request can not be completed successfully.
The ALS recovery pulse interval is invalid.
The ALS recovery pulse duration is invalid.
The current setting does not support the specified ALS
mode.
All enabled routers are required to have the same area.
A software download is in progress. Configuration
changes that result in a card reboot cannot take place
during a software download. Please try again after the
software download is done.
The payload configuration and card mode are
incompatible.
A DCC is present.
An error occurred during provisioning: {0}
Multishelf cannot be disabled. {0}
The LAN configuration is invalid.
Invalid card(s) are present. Please remove all
non-MSTP cards and try again.
Error Messages
Description
One of the following conditions is
present: duplicate shelf positions,
invalid shelf positions, or concurrent
movement (two CTC sessions are
attempting to rearrange the shelves at
the same time.)
Refer to the error message text.
The end points of an internal
patchcord should have compatible
wavelengths.
CTC was unable to initiate the wizard
due to the specified reason.
A communication failure occurred.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
A data communication channel (DCC)
already exists.
CTC was not able to provision the
specified port or card.
Multishelf is not supported on
equipment, is already disabled, or
modules on the shelf are currently in
use.
Verify the LAN configuration.
Non-DWDM cards cannot be added
to an a DWDM node. Remove the
cards.