Cisco NCS 2000 series Troubleshooting Manual page 599

Error Messages
Error/Warning
ID
EID-6394
EID-6397
EID-6398
EID-6482
EID-6487
EID-6488
EID-6489
EID-6490
EID-6545
EID-6546
EID-6547
EID-6548
EID-6549
EID-6550
EID-6551
EID-6552
EID-6553
EID-6601
EID-6602
Error/Warning Message
The maximum number of CVLAN ranges cannot
exceed 48 in selective QinQ mode.
Unable to update the FPGA as the STANBY CTX is
not ready.
Unable to update the FPGA as the database is busy
saving recent modifications.
The storm control threshold value must be in range
[{0}-{1}].
Error while setting DISABLE FEC on {0}.
Error while setting ENHANCED FEC on {0}.
Error while setting STANDARD FEC on {0}.
Error while setting SD BER on {0}.
An error occurred while reading actual channels.
An error occurred while setting actual channels.
Valid License is not available on this card.
License Operation Error.
License is not supported.
The Product ID of the card does not support Licensing.
The card is not in provisioned state, hence this license
data cannot be fetched currently
License operation failed due to Communication failure
with the line card.
License file size has exceeded the limit
The client ports are provisioning on the ports before
deleting.
Incompatible Operating Mode is provisioned.
The Following Operating Modes are not Compatible:
Transponder (4GFC TXP) with 8GFC Transponder
(8GFC TXP).
Description
Refer to the error message text.
Retry later.
Retry later.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Retry after installing a permanent
license.
Refer to the error message text.
The license you are installing is not
supported on the card.
Licensing is not supported on the card.
Retry after the card is provisioned.
Check if the line card is installed
correctly.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Cisco NCS 2000 series Troubleshooting Guide, Release 11.0
Error Messages Reference
553