Mitsubishi MELSEC Q Series Programming Manual page 280

BIN(P),DBIN(P)
(2) The following program converts the BCD data at X10 to X37 to BIN when X8 is ON, and stores it
at D0 and D1.
(Addition of the BIN data converted from BCD at X20 to X37 and the BIN data converted
from BCD at X10 to X1F)
BCD digital switch
Input power supply
X37 to X34 X33 to X30 X2F to X2C X2B to X28 X27 to X24 X23 to X20 X1F to X1C X1B to X18 X17 to X14 X13 to X10
Programmable Controller Output Module
[Ladder Mode] [List Mode]
Instruction Device
Step
If the data set at X10 to X37 is a BCD value which exceeds 2147483647, the value at D0
and D1 will be a negative value, because it exceeds the range of numerical values that can
be handled by a 32-bit device.
6-78