Mitsubishi MELSEC Q Series Programming Manual page 218

Common instruction 1/2

Hide thumbs Also See for MELSEC Q Series:

Table of Contents

(4) The results of the comparison operations for the individual instructions are as follows:

(5) If all comparison results stored n points from

signal) goes ON.

Operation Error

(1) In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and

an error code is stored into SD0.

• The range of the device n points from a device designated by

relevant device.

• The device range for n points starting from the device designated by

device range for n points starting from the device designated by

• The device range for n points starting from the device designated by

device range for n points starting from the device designated by

Program Example

(1) The following program compares, when X20 is turned ON, the data stored at D100 to D103

with the data stored at R0 to R3 and stores the operation result into the area starting from

[Ladder Mode]

Operation Result

are ON (1), SM704 (block comparison

Operation Result

(Error code: 4101)

overlaps with the

(Error code: 4101)

overlaps with the

(Error code: 4101)

Show Quick Links

Chapters

Table of Contents

Melsec l series