Timers (Out T,Outh T) - Mitsubishi MELSEC Q Series Programming Manual

OUT T,OUTH T
5.3.2

Timers (OUT T,OUTH T)

OUT T,OUTH T
OUT T
(Low-speed timer)
OUTH T
(High-speed timer)
OUT ST
(Low-speed retentive timer)
OUTH ST
(High-speed retentive timer)
Setting
Data
D
Set value
*1: The value setting for the timer cannot be designated indirectly.
*2: Timer values can be set only as a decimal constant (K). Hexadecimal constants (H) and real numbers
Function
(1) When the operation results up to the OUT instruction are ON, the timer coil goes ON and the
timer counts up to the value that has been set; when the time up status (total numeric value
is equal to or greater than the setting value), the contact responds as follows:
5-22
Command
Command
Command
Command
Command
Command
Command
Command
: Timer number (bit)
D
Set value : Value set for timer (BIN 16 bits *1)
Internal Devices
R, ZR
Bit Word
–– ––
(Only T)
(Other
––
than T, C)
@D0
T0
See Section 3.4 for further information on indirect designation.
cannot be used for timer settings.
A Contact
B Contact
High
Basic
performance
K50 Set value
Setting in the range
T0
from 1 to 32767 is valid.
D10 Set value
Data register value in
T0
the range from 1 to
32767 is valid.
Set value
H K50
Setting in the range
T0
from 1 to 32767 is valid.
H D10
Set value
Data register value in
T0
the range from 1 to
32767 is valid.
K50
Set value
Setting in the range
ST0
from 1 to 32767 is valid.
D10 Set value
Data register value in
ST0
the range from 1 to
32767 is valid.
H K50
Set value
Setting in the range
ST0
from 1 to 32767 is valid.
H D10
Set value
Data register value in
ST0
the range from 1 to
32767 is valid.
J \
U \G
Bit Word
–– ––
––
Indirect designation is
not permitted.
Continuity
Non-continuity
Process
Redundant Universal LCPU
Constants
Zn Other
K
–– –– ––
–– ––
*2