Mitsubishi MELSEC Q Series Programming Manual page 78

Category
SCL
SCLP
Point-by-
point
coordinate
data
DSCL
DSCLP
SCL2
SCL2P
X or Y
coordinate
data
DSCL2
DSCL2P
2-50
Table 2.30 Special Function Instructions (Continued)
Symbol
SCL S1 S2 D
SCLP S1 S2 D
DSCL S1 S2 D
DSCLP S1 S2 D
SCL2 S1 S2 D
SCL2P S1 S2 D
DSCL2 S1 S2 D
DSCL2P S1 S2 D
Processing Details
• Executes scaling for the scaling
conversion data (16-bit data units)
specified by (S2) with the input value
specified by (S1), and then stores the
result into the device specified by (D).
The scaling conversion is executed
based on the scaling conversion data
stored in the device specified by (S2) an
up.
• Executes scaling for the scaling
conversion data (32-bit data units)
specified by (S2) with the input value
specified by (S1), and then stores the
result into the device specified by (D).
The scaling conversion is executed
based on the scaling conversion data
stored in the device specified by (S2) an
up.
• Executes scaling for the scaling
conversion data (16-bit data units)
specified by (S2) with the input value
specified by (S1), and then stores the
result into the device specified by (D).
The scaling conversion is executed
based on the scaling conversion data
stored in the device specified by (S2)
and up.
• Executes scaling for the scaling
conversion data (32-bit data units)
specified by (S2) with the input value
specified by (S1), and then stores the
result into the device specified by (D).
The scaling conversion is executed
based on the scaling conversion data
stored in the device specified by (S2)
and up.
Execution
Condition
4 -
7-329
4 -
4 -
7-333
4 -