Alarm Profile Commands; Alarm Profile Show Command; Figure 258 Alarm Profile Show Command Example - ZyXEL Communications IES-1248-71 User Manual

Chapter 55 ADSL Commands
Table 102 ToneDiag Command (continued)
LABEL
log(dB)
QLN(dBm)
SNR(dB)

55.3 Alarm Profile Commands

Configure alarm profiles to set alarm settings and thresholds for the ADSL ports.

55.3.1 Alarm Profile Show Command

Syntax:
ras> adsl alarmprofile show [profile]
where
[profile]
Displays the settings of the specified alarm profile (or all of them if you do not specify one).
The following example displays the default alarm profile (DEFVAL).

Figure 258 Alarm Profile Show Command Example

ras> adsl alarmprofile show DEFVAL
01. DEFVAL
Thresh15MinLofs
Thresh15MinLoss
Thresh15MinLols
Thresh15MinLprs
Thresh15MinESs
ThreshFastRateUp
ThreshInterleaveRateUp
ThreshFastRateDown
ThreshInterleaveRateDown
InitFailureTrap(1-enable, 2-disable):
Thresh15MinFailedFast
Thresh15MinSes
Thresh15MinUas
390
DESCRIPTION
This is a format for providing channel characteristics. It provides magnitude
values in a logarithmic scale. This can be used in analyzing the physical
condition of the ADSL line.
The Quiet Line Noise for a DMT sub-carrier is the rms (root mean square) level
of the noise present on the line, when no ADSL signals are present. It is
measured in dBm/Hz. The QLN can be used in analyzing crosstalk.
This is the upstream and downstream Signal-to-Noise Ratio (in dB). A DMT
sub-carrier's SNR is the ratio between the received signal power and the
received noise power. The SNR can be used in analyzing time dependent
changes in crosstalk levels and line attenuation (such as those caused by
temperature variations and moisture).
The name of an alarm profile.
=
(sec):
(sec):
(sec):
(sec):
(bps):
(bps):
(bps):
(bps):
:
(sec):
(sec):
ATU-C ATU-R
---------- ----------
0 0
0 0
0 ---
: 0
0 0
0 0
0 0
0 0
0 0
2 ---
0 ---
0 0
0 0
IES-1248-71/73 User's Guide
0