Senderized Operation For Did And Two-Way Loop Dr Trunks - Avaya Nortel Communication Server 1000 Reference
Circuit card reference
Hide thumbs
Also See for Nortel Communication Server 1000:
- Manual (570 pages) ,
- Configuration manual (350 pages) ,
- Hardware installation and maintenance (262 pages)
Table of Contents
Advertisement
Figure 120: Two-way, loop DR, TIE trunk call connection sequence - outgoing call to far-end PBX
Senderized operation for DID and two-way loop DR trunks
Incoming calls
If the far-end is senderized, the near-end can operate in any mode: Immediate Start (IMM),
Delay Dial (DDL) or Wink (WNK) start, as assigned at the STRI prompt in the Trunk
Administration program LD 14. See
incoming call through senderized, tandem PBX from a CO/FX/WATS trunk
Circuit Card Reference
Figure 121: Two-way, loop DR, TIE trunk call states -
Operation
on page 405.
July 2011
403
Advertisement
Table of Contents
