Configuring The Nt5D97 - Avaya Nortel Communication Server 1000 Reference

NT5D97 Dual-port DTI2 PRI2 card
3. If the NT5D97 card is being completely removed, not replaced, remove data from
4. Remove cross connections at MDF to wall-mounted cross-connect terminal.
5. Tag and disconnect cables from card.
6. Rearrange Clock Controller cables if required.
7. Remove the DDP2 card only if both loops are disabled. If the other circuit of a DDP2
8. Pack and store the NT5D97 card and circuit card.

Configuring the NT5D97

After the NT5D97 DDP2 is installed, configure the system using the same procedures as the
standard NT8D72BA PRI2.
Consider the following when configuring the NT5D97 DDP2 card:
• The CS 1000 software allows four ports to be defined for the NT6D80 MSDL. The DDCH
(NTBK51AA/NTBK51CA) card has only two ports, 0 and 1; therefore, ports 2 and 3 must
not be defined when using the NTBK51AA/NTBK51CA.
• Port 0 of the NTBK51AA/NTBK51CA can only be defined to work with Loop 0 of the
NT5D97 DDP2 card, and Port 1 of the NTBK51AA/NTBK51CA can only be defined to
work with Loop 1 of the NT5D97. This relationship must be reflected when configuring a
new DCH in LD 17 (in response to the DCHL prompt, enter either 0 or 1 when specifying
the loop number used by the DCH).
• You cannot define one of the DDP2 loops for the NTBK51AA/NTBK51CA DDCH, and the
other loop for the NT6D11AF/NT5K75AA/NT5K35AA DCH card or the NT6D80 MSDL.
• When configuring the NT5D97 DDP2 in DTI2 outgoing dial pulse mode, a Digit Outpulsing
patch is required.
290 Circuit Card Reference
The associated DCHI might need to be disabled first. The faceplate switch ENB/
DIS should not be disabled until both PRI2/DTI2 loops are disabled first.
memory.
Caution:
Clock Controller cables connecting the Clock Controller and DDP2 card must
NOT be routed through the center of the cabinet past the power harness. Instead,
they should be routed around the outside of the equipment shelves.
card is in use, DO NOT remove the card. The faceplate switch ENB/DIS must be in
the OFF (DIS) position before the card is removed, otherwise the system
initializes.
Comments? infodev@avaya.com
July 2011