Configuration - Avaya Nortel Communication Server 1000 Reference

of pins. Normally, these pin positions are cabled to 50-pin connectors at the I/O panel in the
rear of each module for connection with 25-pair cables to the MDF.
The information in
provided as a reference and diagnostic aid at the backplane, because the cabling arrangement
can vary at the I/O panel. See Communication Server 1000M and Meridian 1 Large System
Installation and Configuration (NN43021-310) for cable pinout information for the I/O panel.
Table 160: NT8D02 Digital Line card - backplane pinouts
Backplane Pinout*
12A
13A
14A
15A
16A
17A
18A
19A
62A
63A
64A
65A
66A
67A
68A
69A
*These pinouts apply to both the NT8D37 and NT8D11 backplanes

Configuration

This section outlines the procedures for configuring the switches and jumpers on the NT8D02
Digital Line card and configuring the system software to properly recognize the card.
98: Digital line card - jumper block and switch locations
and jumper blocks are located on this board.
Circuit Card Reference
Table 160: NT8D02 Digital Line card - backplane pinouts
Lead Designations
Line 0, Ring
Line 1, Ring
Line 2, Ring
Line 3, Ring
Line 4, Ring
Line 5, Ring
Line 6, Ring
Line 7, Ring
Line 8, Ring
Line 9, Ring
Line 10, Ring
Line 11, Ring
Line 12, Ring
Line 13, Ring
Line 14, Ring
Line 15, Ring
Backplane Pinout* Lead Designations
12B
13B
14B
15B
16B
17B
18B
19B
62B
63B
64B
65B
66B
67B
68B
69B
on page 361 shows where the switches
Configuration
on page 359 is
Line 0, Tip
Line 1, Tip
Line 2, Tip
Line 3, Tip
Line 4, Tip
Line 5, Tip
Line 6, Tip
Line 7, Tip
Line 8, Tip
Line 9, Tip
Line 10, Tip
Line 11, Tip
Line 12, Tip
Line 13, Tip
Line 14, Tip
Line 15, Tip
Figure
July 2011 359