Applications; Paging Trunk Operation - Avaya Nortel Communication Server 1000 Reference

Port B
Note:
When Port B is the call originating port. If the Universal trunk card is the originating port,
the UTC pads are out, the Port B (PE CO/FX/WATS) pads are in.

Applications

The optional applications, features, and signaling arrangements for each trunk are assigned
through unique route and trunk data blocks.

Paging trunk operation

A universal trunk card unit can be configured as a paging trunk. Configure units as paging
trunks in the Trunk Data Block program LD 14 and assign routes in the Route Data Block
program LD 16.
Figure 132: Connecting paging equipment to the NT8D14 Universal Trunk card (typical)
page 430 shows a typical connection from customer-provided equipment to unit 0 on a
universal trunk card that can be installed in slots 1, 2, and 3 in a Media Gateway and slots 7,
8, 9, and 10 in a Media Gateway Expansion. See Communication Server 1000M and Meridian
1 Large System Installation and Configuration (NN43021-310) for trunk wiring information.
Circuit Card Reference
Port B pads
Transmit Receive
D to A A to D
Universal Trunk Port-to-port loss (dB)
Pads
Transmit Receive
D to A A to D Universal
Applications
Port B to Universal
trunk
trunk card to
card Port B
July 2011
on
429