Software Service Changes - Avaya Nortel Communication Server 1000 Reference

NT8D41BA Quad Serial Data Interface Paddle Board
Table 200: NT8D41BA DTE/DCE/Fiber switch settings
DTE (terminal)
DCE (modem)
NT1P61 (Fiber)
DTE (terminal)
DCE (modem)
NT1P61 (Fiber)
DTE (terminal)
DCE (modem)
NT1P61 (Fiber)
DTE (terminal)
DCE (modem)
NT1P61 (Fiber)

Software service changes

Once the NT8D841BA QSDI paddle board is installed in the system, the system software
needs to be configured to recognize it, using the Configuration Record program LD 17.
Instructions for running this program are found in Software Input/Output Reference —
Administration (NN43001-611).
Some of the prompts that are commonly used when running the Configuration Record program
LD 17 are shown in
board. on page 470 These parameters must be set for each port if both ports are being
used.
Table 201: LD 17 - Prompts to configure the NT8D841Ba paddle board.
Prompt
REQ:
TYPE:
470 Circuit Card Reference
Mode
on on on off on off off on off on off on
off off off on off on on off on off on off
on on on on on off on on on off on off
Port 2 — SW 5
on on on off on off off on off on off on
off off off on off on on off on off on off
on on on on on off on on on off on off
on on on off on off off on off on off on
off off off on off on on off on off on off
on on on on on off on on on off on off
on on on off on off off on off on off on
off off off on off on on off on off on off
on on on on on off on on on off on off
Table 201: LD 17 - Prompts to configure the NT8D841Ba paddle
Response
CHG Change configuration
ADAN Configuration type
Comments? infodev@avaya.com
Port 1 — SW 3
1 2 3 4 5 6
Port 3 — SW 7
Port 4 — SW 9
Description
Port 1 — SW 2
1 2 3 4 5
Port 2 — SW4
Port 3 — SW 6
Port 4 — SW 8
6
July 2011