Avaya Nortel Communication Server 1000 Reference page 343

If the problem persists, manually disable the card by entering the
Follow the steps described in
SYSTEM DISABLED—SELF-TESTING:
Table 151:
Cause:
The MSDL card has reset itself or the system has reset the card to perform self-tests.
Self-tests are in progress.
Action:
Wait until self-tests are completed. Under some circumstances, the self-tests may
take up to 6 minutes to complete.
Take the action described in the appropriate section below ("SYSTEM DISABLED
—SELF-TESTS PASSED" or "SYSTEM DISABLED—SELF-TESTS FAILED").
SYSTEM DISABLED—SELF-TESTS PASSED
Table 152:
SYSTEM DISABLED—SELF-TESTS FAILED:
Cause:
The card did not pass self-tests. These tests repeat five times. If unsuccessful,
autorecovery stops until midnight unless you take action.
Circuit Card Reference
Cause:
The MSDL card passed self-tests. The system automatically downloads the
MSDL base code, if needed, and attempts to enable the card using autorecovery.
If a diagnostic program (overlay) is active, the downloading of the MSDL base
code occurs later.
Action:
Wait to see if the system enables the card immediately. If the MSDL is enabled,
no further action is necessary.
If the MSDL base code download fails five times, autorecovery stops. The
following appears in response to the
MSDL 10: SYS DSBL—SELFTEST PASSED
NO RECOVERY UNTIL MIDNIGHT: FAILED BASE DNLD 5 TIMES
SDI 10 DIS PORT 0
AML 11 DIS PORT 1
DCH 12 DIS PORT 2
AML 13 DIS PORT 3
Error messages usually indicate the problem in this case. See
MSDL on page 337.
Previously operating MSDL cards
STAT MSDL x
System disabled actions
DIS MSDL x
on page 340.
command;
Maintaining the
July 2011
.
343