Avaya Nortel Communication Server 1000 Reference page 614

NTDW56 and NTDW59 Common Processor Media Gateway card
1. Power off and remove the CP MG card from the Media Gateway cabinet or
2. Remove the four Phillips screws on the bottom of the CP MG card to unsecure the
3. Slide the defective hard drive off the SATA connector J7. and remove the defective
4. Place the replacement hard drive on the CP MG card and slide the replacement
5. Secure the replacement hard drive from the bottom of the CP MG card with the four
You can reinstall the CP MG card into the Media Gateway cabinet or chassis. If the replacement
hard drive does not have Linux Base pre-installed, install the Linux Base software from a
bootable USB 2.0 flash drive. For more information, see Nortel Communication Server 1000
New in this Release, NN43001-115.
614 Circuit Card Reference
chassis.
hard drive, see Figure 170: CP MG card hard drive screws
Figure 170: CP MG card hard drive screws
hard drive from the CP MG card.
hard drive into SATA connector J7. See
connector on page 614.
Figure 171: CP MG card hard drive connector
Phillips screws.
Comments? infodev@avaya.com
on page 614.
Figure 171: CP MG card hard drive
July 2011